South Pole Telescope: Guard Ring
Six years after Thompson Metal Fab supplied the South Pole Telescope’s 125-Ton support foundation (see above, under the telescope), TMF was contracted again for the supply of the aluminum guard ring that fits behind the dish of the telescope. The intent of the guard ring and panels is to help improve the signal received from the telescope.
Due to the remote field location of the project, it was critical that the guard ring fit to the pre-existing telescope without issue. The guard ring was fabricated and erected in our shop to tolerances much tighter that typical AISC allowance.
Project Highlights
- Manufacturing/Survey within thousandths of an inch
- Success with logistical delivery challenges
AGP’s shiploader, which is used for loading grain, suffered a mechanical failure which led to structural damage in the boom and portal
Learn More
The Honolulu Authority Rail Transit (HART) project will provide approximately 22-miles of above ground light rail capabilities to residents and visitors of
Learn More
Intel E-Houses
Thompson Metal Fab fabricated three modular E-Houses for Integrated Systems Group which went out to Hillsboro’s Intel location. These modules
Learn More
Grant Street Pier
Thompson Metal Fab in Vancouver WA was honored to fabricate the mast, base, and anchors for the keystone community
Learn More
OHSU Portland Aerial Tram
PROJECT OVERVIEW
Thompson Metal Fab shop fabricated and installed all major tram steel requirements for the lower station,
Learn More
Transbay Transit Center Support Structure
PROJECT OVERVEW
The Transbay Transit Center Project’s below grade support structure portion consisted of fabricating a series
Learn More
Intel LARK E-Houses
Thompson Metal Fab fabricated two modular E-Houses for Integrated Systems Group which went out to Hillsboro’s Intel location. These
Learn More
Alyeska Pump Station Electrification Project
Pipe Racks & Support Steel
Thompson Metal Fab fabricated Pipe Rack Modules & Support Steel for the
Learn More
Floating Staircases (Hill Climb) Washington State Convention Center
Thompson Metal Fab was a strategic partner for American Bridge on this huge expansion
Learn More
HAYWARD FIELD
Hayward Field is the track and field venue for the University of Oregon in Eugene, Oregon. It is arguably one
Learn More
PROJECT OVERVIEW
Thompson Metal Fab shop fabricated a 580 ton launch table for the Boeing Delta IV project. The launch table measured
Learn More
Communication Towers Anchorage to Fairbanks
Project Overview
Due to extreme weather conditions between Anchorage and Fairbanks, Alaska, steel shaft communication towers are
Learn More
Ice Harbor Dam 40-Ton Gantry Crane
Project Overview
Advanced Crane Technologies hired TMF to fabricate a new 40-Ton Gantry Crane and Trolley
Learn More
BART Oakland Connector
Thompson Metal Fab is not a stranger to projects with tight tolerances, and this tram project might take the
Learn More
South Pole Telescope: Guard Ring
Six years after Thompson Metal Fab supplied the South Pole Telescope’s 125-Ton support foundation (see above, under
Learn More